Wednesday, April 16, 2008

Aerification: The Process

Each area on the golf course is treated differently, but the end result is all the same. We are trying to alleviate the surface compaction that exists on each of the play areas so that the plant is better equipped to perform well for the upcoming season.

Greens:
The process begins with an application of sand to the surface before they are aerified. This is done so that the newly created holes are not closed immediately by the weight of the equipment applying the sand. An additional benefit of this is that the sand on the surface is forced down into the profile by the aerifier tines. After aerification has been completed and the sand is dry the greens are drug with a coco mat to fill the holes with sand.
Applying Sand To The Green

Aerifying The Green
Close up of Aerification Holes


Final Product



Fairways:
The fairways were de-thatched rather than aerified so that the surface disruption is not as significant. Typically the fairways are only aerified in the fall. The Graden verticutter was set to a depth of 1” below the surface and was done in two directions to remove maximum amount of thatch without causing surface damage. The thatch was drug with a steel mat to break up the debris and the remainder was then blown off. Next the Bentgrass seed was spread and compost was applied on top. After the compost material was dry, the fairways were once again drug in with a steel mat to evenly distribute the seed compost mix.


Verti-Cutting Fairways

Close Up Of Thatch Removed From Fairway
Seeding The Fairways
Spreading Compost

Dragging In The Compost


Tees:
The tees were treated in a similar manor as the fairways, but with out the compost application being made.

This whole process takes a staff of 20, every bit of three days to complete with good weather. Throw in the delays we experienced this spring and the task becomes rather challenging to say the least. I hope this gives everybody a feel for what has taken place on the golf course for the last three days.

0 comments: